The most challenging part of this project is coding. I am using a force sensor (in the future I will use a temperature sensor) to control both the LEDs and buzzer. I found that I can not write "delay()" in the code for the music, cause it would delay the sensor getting values to control the LEDs. So, I tried to replaced "delay" with "millis", and also rewrote my music code with arrays to make the code more simple. It was really a hard and long time to figure out the write code.
The next step is "getting started with Lilypad Arduino"....
witch was started from blinking a LED light.
Musical Table Mat 1 from Lisa Lee on Vimeo.
Comments